Peaktronics DPC-100
Features
- The DPC-100 DC Production Controller is intended for on/off or open/close control of DC valve actuators rated for 10-30VDC and up to 10 amps of running current
- This variant of our DMI-100 DC Motor Controller is intended for production environments where independent open and close input delays of up to 12 seconds are needed for your process, but a repeat cycle timer is not needed
- The DPC-100 version has a fixed 12 amp current trip to protect the motor, actuator, and valve from excessive electrical current and mechanical force, but is not recommended for torque seating valves
- A wide range of AC and DC control inputs ranging from 1.9VAC / 2.4VDC up to 130VAC / 130VDC can be used
- Electronics surge limiting reduces motor inrush current allowing for smaller size batteries/power supplies and wire
- Low standby current maximizes battery life
- Switchable 2-wire or 3-wire control
- Electrically isolated inputs that allow multiply units to be easily paralleled to the same control signal
- Local/remote modes allow for manual control using onboard buttons in addition to the external control signals
- Electronic brake reduces the need for a mechanical brake
DPC-100 Controller
The Peaktronics DPC-100 DC Production Controller is used to interface common electrical control signals to DC actuators. The wide operating range of the DPC-100 (10 to 30 VDC with loads up to 10A continuous or 60A locked rotor) allows for operation in a large number of actuator applications. The unit provides all necessary motor drive, protection, and interface circuitry. For added protection, motor outputs are electrically isolated from control inputs.
Brochure / Specs
-
DPC-100/DPC-100A Datasheet
DPC-100/DPC-100A Datasheet